Bluetooth Mode; Aux Mode - Krüger & Matz KM0524 Mode D'emploi

bluetooth Mode

pairing:
1. Make sure the speaker is turned on.
2. please keep the speaker and external device close to each other when pairing.
3. press and hold button to enter pairing mode. The speaker will issue a voice prompt.
4. Enable the Bluetooth function on the external device and search for new Bluetooth devices.
5. Select and connect with this device (KM Beat). Enter password: "0000" if necessary.
6. The speaker will issue a sound signifying successful pairing.
Notes:
• If pairing is not completed within 3 minutes, the speaker will quit the pairing mode. In
that case, repeat pairing process to pair the speaker with external device.
• Every time the speaker is switched on, it will connect to last connected device
automatically. please note, your device must be on with Bluetooth function turned on.
• When playing music from a Bluetooth device, the Bluetooth mode is always given
priority. When in Bluetooth mode you can switch to "AUX" by pressing the Mode
button when your Bluetooth device is paused. While in AUX mode, the green circular
light behind the power button will remain on. However, as long as the Bluetooth
connection is not terminated, it will remain the prime connection and will override the
"AUX" connection when it is played and then if paused again, the AUX connection will
reestablish after a three second delay.

auX Mode

1. Use 3,5 mm AUX cable and connect one end of the cable into the speaker's 3,5 mm input.
8
2. The speaker will automatically enter AUX mode.
3. Connect the other end into the 3,5 mm input of the device you wish to play music from.
4. Start playing music from your device.
Note: One more speaker can be connected via the supplied 3.5 mm audio cable (only in
AUX mode). To accomplish this simply insert one end of a second audio cable into the
headphone port on speaker A and the other end of that cable into the AUX of speaker B.
Inserting the cable into the headphone port of speaker A will disable the speakers (as the
headphone connection is now active), to reactivate the speakers, press and hold the Mode
button on speaker A for 5 seconds.
nFc
1. Make sure the speaker is turned on.
2. Enable NFC function on the external device you are going to connect to.
3. Bring the external device close to the NFC area of the speaker. The devices will connect
automatically.
charging
1. Connect one end of the USB charging cord to the microUSB charging port on the side
of the speaker.
2. Connect the other end of the USB charging cord in the USB port of power adapter and
then plug it into the socket.
3. When red light is on, the speaker is charging.
4. When the battery is fully charged, red light goes off.
Owner's manual