First Steps - White-Westinghouse CAMO Tout À Propos De L'utilisation Et L'entretien

FIRST STEPS

This Use & Care Guide provides general operating
instructions for your model. Use the unit only
as instructed in this Use & Care Guide. Before
starting the unit, follow these important
first steps.
Location
Choose a place that is near a grounded
electrical outlet.
For the most efficient operation, the appliance
should be located where surrounding
temperatures will not exceed 110°F (43°C).
Temperatures of 32°F (0°C) and below will
NOT affect operation. Additional compressor
heaters are not recommended.
Allow space around the unit for good air
circulation. Leave a 3 inch (75 mm) space on
all sides of the unit for adequate circulation.
3" (75 mm)
3" (75 mm)
3" (75 mm)
Installation
NOTE

The exterior walls of the unit may become
quite warm as the compressor works to
transfer heat from the inside. Temperatures
as much as 30° F warmer than room
temperature can be expected. For this reason
it is particularly important in hotter climates
to allow enough space for air circulation
around your appliance.
4
3" (75 mm) Air Space
3" (75 mm)
3"
(75 mm)
3" (75 mm)
Leveling
The appliance must have all bottom corners
resting firmly on a solid floor. The floor must be
strong enough to support a fully loaded unit.
NOTE

It is VERY IMPORTANT for your appliance
to be level in order to function properly. If the
unit is not leveled during installation, the door/
lid may be misaligned and not close or seal
properly, causing cooling, frost or moisture
problems.
To level Upright Units:
After discarding crating screws, use a
carpenter's level to level the appliance from
front to back. Adjust the plastic leveling feet in
front, ½ bubble higher, so that the door closes
easily when left halfway open.
To level Chest Units:
If needed, add metal or wood shims between
feet pads and floor.
CAUTION
To allow door to close and seal properly, DO
NOT let food packages extend past the front
of shelves.
Repositioning the Mid-Level
Basket
(some models)
1. To remove the support-hanging basket,
press upward on underside of front of
support to release from shelf rod.
2. Rotate front under the shelf, and then
slide support-hanging basket forward to
remove from back shelf rod.
3. To remove shelf grommet, slide away
from wall, then pull from rod.
4. Repeat steps 1-3 for other side.
5. With the shelf installed, press the 2 shelf
grommets down onto the rod that is
: