GEZE GC 334 Manuel D'utilisation page 6

1
MOUNTING THE PROFILE
Mount the profiles as close as possible to the closing edge. Leave 2 cm
for the black end caps. Take the position of the white clips into account
before drilling and fastening the screws.
2
POSITIONING THE MODULES
3
WIRING
GC 334
2 cm
180°
/
/
To loosen the modules, please use
a screwdriver.
Place the transmitter (TX) next to the door
edges that needs to be protected.
Position the angle adjustment clip next to the
transmitter.
If necessary, turn the module and
reposition the clips as indicated.
1. Detach the clips
2. Turn them by 180°
3. Reattach
The module connected to the door controller
becomes the MASTER.
NO POWER
NO DETECTION
DETECTION
Plug the SLAVE
CABLE between
the modules in
one of the two
placements.
NO NC