Using Omnipass - Fujitsu LIFEBOOK S762 Guide D'utilisation

Once OmniPass has successfully acquired the fingerprint, the Verify Fingerprint screen will automatically appear.
3
To verify your enrolled fingerprint, place your fingertip on the sensor and hold it there as if you were having a
fingerprint captured. Successful fingerprint verification will show a green fingerprint in the capture window and
the text Verification Successful under the capture window.
After you are done enrolling and verifying your fingerprints, you will have the option to Enable PBA with enrolled
4
finger. If you enable this option, then you must choose two fingers to save in PBA. If you have enrolled
successfully, the Finger Enrollment Status in PBA screen will state Finger saved in PBA successfully.
I
F YOU ENABLE
P
ASSWORDS

Using OmniPass

You are now ready to begin using OmniPass. Used regularly, OmniPass will streamline authentications.
Fingerprint Sensor LED Indications
Once OmniPass is installed, you will be able to determine the state of the fingerprint sensor by the condition of the
LEDs above and below the sensor.
• Flashing blue: Indicates your finger is on the sensor and it is ready to accept a fingerprint swipe.
• Flashing green: The fingerprint swipe was successful and the fingerprint was accepted.
• Flashing red: The fingerprint swipe was unsuccessful and the fingerprint was rejected.
Password Replacement
You will often use the password replacement function. When you go to a restricted access website (e.g., your bank,
your web-based email, online auction or payment sites), you are always prompted to enter your login credentials.
OmniPass can detect these prompts and you can teach OmniPass your login credentials. The next time you go to that
website, you can authenticate with your fingerprint to gain access.
PBA ,
ON YOUR SYSTEM YOU MUST SET THE
" 50
ON PAGE FOR ADDITIONAL INFORMATION
169 - Introducing the Optional Fingerprint Sensor Device
S P P
UPERVISOR ASSWORD AND ASSWORD ON
.
B . S "H D
OOT SETTINGS EE ARD ISK
D
RIVE