Fujitsu LIFEBOOK S762 Guide D'utilisation page 122

Table des Matières

Publicité

Click [Next] to confirm full hard drive restoration. (All data on HDD will be deleted).
8
Agree to EULA by selecting [Agree] option and clicking [Next].
9
Click [Next] on the Recovery Disk Check screen to verify that the bootable disk has been inserted into the optical
10
drive.
The Checking for Recovery Disk screen appears followed by the prompt to insert the first disk. Click [OK] to
11
continue. Repeat this step for all disks. After all recovery disks have been checked and the check has been
completed, click [Next]
Reinsert the first recovery disk and click [Next]
12
Click [OK] when you receive the final warning informing you that all data on drives C: and D: will be lost. This starts
13
the recovery process.
Follow the prompts to insert the next recovery disks and click [OK].
14
After the copying of the factory image to the HDD completes and the factory image is restored, follow the prompt
15
to insert bootable disk.
After the restore process is complete, click [Finish] to restart the system. The computer will restart automatically
16
and then go through the first boot process.
Changing BIOS settings between Windows 8 32-bit and Windows 8 64-bit
In order to install a 32-bit version of Windows 8 and to be able to boot from 32-bit media, you must disable the
Security Boot option in the BIOS settings. Switching back to the 64-bit version of Windows 8 from the 32-bit version
of Windows 8 will require you to revert the above change and to re-enable Secure Boot. If you do not re-enable Secure
Boot, the following product functionalities will not be enabled as it relies on native UEFI (Unified Extensible Firmware
Interface) mode boot:
Secure Boot
1
Seamless Boot experience
2
Network unlock for Bitlocker for systems with a Trusted Platform Module (TPM)
3
eDrive support
4
116 - Restoring Your System Image and Software (Windows 8)

Publicité

Chapitres

Table des Matières
loading

Table des Matières