Dyno Merchandise EasyStitcher Manuel D'utilisation page 5

5. Pull thread from the metal washers to the right and through the Thread Pulling Bar
(Y), Step #3 on machine, in a top to bottom direction.
6. Insert thread through the Lower Thread Guide (W), Step #4 on machine, in a top to
bottom direction.
7. Pull thread down to Thread Guide (T) located just above the Needle (R), inserting
thread from top to bottom.
8. Pull thread downward and insert thread through eye of the Needle (R) using needle
threader. If necessary, raise the Needle by turning the Hand Wheel (D) slightly
clockwise (away from you). Pull thread through eye of needle from left to right of
machine.
9. Raise the Presser Foot (Q) by lifting up on the Presser Foot Lever (AA).
10. Pull about 10 inches of thread through the Needle and lay it on the deck under the
Presser Foot (Q) running in the direction away from you.
To Sew with a Thread Spool:
1. Raise Thread Spindle (A) by grasping the exposed top and pulling upward until the
Thread Spindle is fully extended.
2. Place Thread Spool (B) on the Thread Spindle (A).
3. Pull thread from the Thread Spool (B) and thread it through the Upper Thread Guide
(Z), Step #1 on machine, from right to left.
4. Pull thread over the Tension Adjusting Screw (X) and place it between the two
metal washers behind the Tension Adjusting Screw, Step #2 on ma chine. This
specific placement provides lockstitch tension to the thread.
5. Pull thread from the metal washers to the right and through the Thread Pulling Bar
(Y), Step #3 on machine, in a top to bottom direction.
6. Insert thread through the Lower Thread Guide (W), Step #4 on machine, in a top to
bottom direction.
7. Pull thread down to Thread Guide (T) located just above the Needle (R), inserting
thread from top to bottom.
8. Pull thread downward and insert thread through eye of the Needle (R) using needle
threader. If necessary, raise the Needle by turning the Hand Wheel (D) slightly
clockwise (away from you). Pull thread through eye of needle from left to right of
machine.
9. Raise the Presser Foot (Q) by lifting up on the Presser Foot Lever (AA).
10. Pull about 10 inches of thread through the Needle and lay it on the deck under the
Presser Foot (Q) running in the direction away from you.
5