Redsun E200 Manuel D'utilisation Et D'installation page 52

A sensor failure can have the following effects:
1. If this function is activated, the heating is switched on for 30 % of the time (this prevents the
room from being too cold or overheating)
2. When this function is not activated, the heating is switched off
3.10 Application type (option 11, table 2 on page 53)
This function is used to select the application type of the controller.
(Effective only for PID (PWM))
0 = Radiator Control (= Default)
1 = Water fl oor heating control
3.11 Control algorithm (option 12, table 2 on page 53)
PId = PID with PWM (pulse width modulation)
On:OF = ON/OFF
PWM for fl oor heating or radiator heating
ON/OFF for boiler control or special applications
52