The Saddle Sensor Elements; First Use - Helite B'SAFE Manuel D'utilisation

1. THE SADDLE SENSOR ELEMENTS

1 #2
mm 34mm

2. FIRST USE

All schemas are in a special manual that comes with the user
guide
A. PAIR THE SADDLE SENSOR WITH THE VEST
Before using your B'Safe vest, it is necessary to pair (which means
associate) the vest with the saddle sensor. To do so, you need the
vest, the saddle sensor and the magnet. Make sure the e-cartridge
is connected to the vest.
1. Switch ON the vest
flashes green and you hear a beep.
2. Press the button
Release the button and go to the next step.
3. Place the magnet on the saddle sensor
sign. Please note that you only have 30 seconds to effect this
procedure.
• If you hear a LONG BEEP: the vest and the saddle sensor are
paired.
• If you hear a SHORT BEEP: the vest and the saddle sensor have
already been paired.
User Guide - Saddle Sensor
1 SDU SENSOR:
- Is installed on the bicycle frame.
- Detects impacts on the bicycle.
- Sends signals to the vest.
- Has an autonomy of 5 years (not rechargeable).
1 MAGNET:
You need the magnet for the first use of the B'Safe
airbag system (see page 9) and also for periodic
controls.
3 BRACELETS:
#3
38mm
There are bracelets of different sizes to fix the saddle
sensor on the bicycle (see page 10).
5x35
5x25
4x8
by pressing 3 times the button
for 3 seconds
3 SCREWS, 2 NUTS & 2 HEX
mm
KEYS:
To install the saddle sensor
mm
on the bicycle (see page 10).
mm
until the LED turns blue.
. The LED
over the round
9