WAGNER WallPerfect Flexio 995 Mode D'emploi page 51

WallPerfect Flexio 995 WallPerfect Flexio 995
Problem
Spray jet pulsates
Coating material
causes "paint tears"
Too much fog of
coating material
(Overspray)
Width of paint
spray cannot be
adjusted
Poor covering
capacity on the wall
Coating material
cannot be atomised
Cause
•
Coating material in
container running out
•
Nozzle seal worn
•
Air filter heavily soiled
•
Filter clogged at suction
hose
•
Too much coating material
applied
•
Viscosity of coating material
too low
•
Distance to the object too
large
•
Too much material quantity
•
At a low quantity of material,
wide spray jet selected
(green)
•
Adjustment ring is not
connected to the peg on the
air cap
•
Air screen is clogged up
•
Spray material is too cold
•
Highly absorbent surface
or paint with poor covering
capacity
•
Distance too large
•
The material quantity and
spray jet do not correspond
with each other
•
Multifunction switch is set to
"Clean"
•
Turbine is defect
Remedy
➞ Refill
➞ Replace
➞ Change
➞ Clean filter
➞ Turn the material volume
setting to the left
Spray excess material on the
wall using the inking roller
➞ Reduce the quantity of
material and apply in several
layers
➞ Reduce distance
➞ Turn the material volume
setting to the left
➞ Switch to narrow jet spray
(red)
➞ Connect adjustment ring
and peg
➞ Disassemble and clean the
spray head
➞ The material you are
spraying should be at room
temperature
➞ Cross spray (Fig. 8)
➞ Closer to the object
➞ Optimise the settings
➞ Set the multifunction switch
to "ON"
➞ Please contact Wagner
Service
GB D
49 49