Installation; Before The Installation; Connection Cable - ARTHUR MARTIN AIH633BK Notice D'utilisation

warranty period. The instructions about the
Service Centre and conditions of guarantee
are in the guarantee booklet.

INSTALLATION

WARNING! Refer to Safety
chapters.

Before the installation

Before you install the hob, write down the
information bellow from the rating plate.
The rating plate is on the bottom of the
hob.
Serial number ...........................
Built-in hobs
Only use the built-in hobs after you
assemble the hob into correct built-in units
and work surfaces that align to the
standards.

Connection cable

• The hob is supplied with the connection
cable.
• Replace the damaged mains cable only
with the spare parts cable. Speak to
your local Authorised Service Center.
N
L
One-phase connection - 230 V~
N
L
230V~
Green - yellow
Blue and blue
Black and brown
WARNING! All electrical
connections must be made by a
qualified electrician.
CAUTION! Do not drill or solder
the wire ends. This is strictly
forbidden!
CAUTION! Do not connect the
cable without cable end sleeve.
Two-phase connection
1. Remove the cable end sleeve from
black and brown wires.
2. Remove an insulation of the brown and
black cable ends.
3. Apply a new wire end sleeve of 1.5 mm²
on each cable end. (special tool
required).
Cable cross section
400V 2~N
Two-phase connection - 400 V 2 ~ N
Green - yellow
Blue and blue
Black
Brown
15
N
L1
L2
N
L1
L2