Monacor PS-168 Mode D'emploi page 7

3) Connect the plug of the mains cable (3) to a mains
socket (100 – 240 V~/50 – 60 Hz) and switch on the
unit with the POWER switch (2). The power LED (1)
will light up.
4) Also switch on the units connected to the video out-
puts.
5) If required, modify the video output level and thus
readjust the brightness of the picture for each cam-
era channel by means of the four sliding switches
VIDEO GAIN ADJ. (5) [see table below]. This will
compensate level loss caused by a long connection
cable between the camera and the power supply
unit.
Switch position
VIDEO GAIN ADJ.
OFF +
OFF +
OFF -
OFF -
OFF + OFF
OFF + OFF
or
OFF - OFF
OFF - OFF
OFF +
OFF +
OFF -
OFF -
OFF + OFF
OFF + OFF
or
OFF - OFF
OFF - OFF
OFF +
OFF +
OFF -
OFF -
5 Specifications
Video inputs/outputs: . . . . . 1 Vpp/75 Ω
Ambient temperature: . . . . . 0 – 40 °C
Power supply: . . . . . . . . . . . 100 – 240 V~/50 – 60 Hz
Power consumption: . . . . . . 70 VA
Dimensions: . . . . . . . . . . . . 350 x 50 x 340 mm
Weight: . . . . . . . . . . . . . . . . 3.3 kg
Subject to technical modification.
All rights reserved by MONACOR
GmbH & Co. KG. No part of this instruction manual
may be reproduced in any form or by any means for
any commercial use.
Brightness of the picture
basic setting
+
+
brightness increased
-
-
brightness further
increased
+
+
brightness reduced
-
-
brightness further reduced
® INTERNATIONAL
GB
7