Start-Up Procedure; Final Checks - Hoshizaki FM-600ALHE Notice D'installation

Fig. 8
3) Attach grey flexible outlet hoses (accessories) to
the R3/4 fittings as indicated, confirming fitment of
rubber washers before finally hand tightening the
joints. These pipes can be cut to length as
necessary to suit position of main drain.

6. START-UP PROCEDURE

1) Check that the power supply cord is disconnected.
2) Move the Operation Switch on the Operation Panel
to the "ON" position.
3) Open the water supply tap.
4) Connect the power supply and energise.
5) The Display will illuminate in the "ICE" mode.
6) The following should occur in sequence:
a) Water Reservoir will fill.
b) Gear Motor will start.
c) Solenoid valves will energise/open.
Note: Check the operation of the compressor
system and ensure a complete refrigerant
charge.
Ice Button Display
ICE
DRAIN
STOP
MODE
ICE STOP RESET
Once STOP Button is pushed,
ICE Button cannot start ice
production for 20 min.
Operation Panel
Fig. 9
Water Supply Tap
Inlet Hose
Stop Button
Reset Button
Operation Switch
7) The icemaker's suction pressure regulator is set to
an evaporating temperature of -25°C (FM-600), -22°C
(FMN-440) or -18°C (FM-481). DO NOT change
this setting.
8) Ensure the refrigeration system's running suction
pressure is 1 bar (FM-600), 1.4 bar (FMN-440) or
2.1 bar or less (FM-481) to provide the correct
evaporating temperature.
IMPORTANT
1. Check the conditions and quality of the ice
production.
2. Do not use ice produced in the trial run. It
might be contaminated with foreign matter in
the water circuit. Discard or flush down the
drain.
3. Clean the Storage Bin before use (see "III. 1.
CLEANING" in Instruction Manual).

7. FINAL CHECKS

1) Is installation free of water leaks?
2) Is the icemaker free from vibration?
3) Are all the panels fixed and secure?
4) Has the user been instructed on correct machine
use and handed the Instruction Manual?
5
ENGLISH