Delay Start - Bosch SuperSilence Plus 39dBA SHE9PT55UC Guide D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Setting the amount of rinse aid
The amount of rinse aid dispensed can be set from "r:00" to "r:06".
To change the setting:
1
Press the [On/Off] button.
Hold down the "A" button (see page 4) and press [Start] until the display indicates "H:00".
2
Release both buttons.
3
Press the "A" button until the display shows "r:05".
4
Press the "C" button to select the desired setting.
5
"r:00" = dispenser is OFF
"r:01" = lowest setting
"r:02" = low setting
"r:03" = medium setting
"r:04" = medium/high setting
"r:05" = high setting
"r:06" = highest setting
Press [Start] to save the setting.
6

Delay Start

You can delay the start of the cycle in one hour increments up to 24 hours.
To set delay start:
Press the [On/Off] button.
1
Press the [+] button until the display jumps to "h:01".
2
Press the [+] or [-] button until the displayed time corresponds with your requirements.
3
h:01 = 1 hour delay
h:24 = 24 hour delay
Press [Start] to activate delay start.
4
To cancel delay start:
1
Press the [+] or [-] button until "h:00" is indicated on the digital display.
2
Press [Start] to save setting.
Cycle Completion Signal
1
Open the door and press the [On/Off] button.
2
Hold down the "A" button (see page 4) and press [Start] until the display indicates "H:00".
Release both buttons.
3
Press the "A" button until the display shows "b:02".
4
Press the "C" button to increase or decrease the tone "b:00" = OFF and "b:03" = LOUDEST
5
Press [Start] to save setting and close the door.
6
Intensive Drying
The final rinse uses a higher temperature which improves the drying results. The running time may
increase slightly.
To turn intensive drying on:
Press the [On/Off] button.
1
Hold down the "A" button (see page 4) and press [Start] until the display indicates "H:00".
2
Release both buttons.
3
4
Press the "A" button until the display shows "d:00".
5
Press the "C" button to turn intensive drying on or off. "d:01" = ON and "d:00" = OFF
Press [Start] to save setting and close the door.
6
13

Publicité

Chapitres

Table des Matières
loading

Table des Matières