Burner Caps And Heads; Burner Bases - Samsung NA30K6550T Série Mode D'emploi

Burner caps and heads

NOTES
Before removing the burner caps and heads, remember their size and location.
Replace them in the same location after cleaning.
Wash burner caps and burner heads in hot, soapy water and rinse with clean
running water. You may scour with a plastic scouring pad to remove burned-on
food particles.
Use a sewing needle or twist tie to unclog the small holes in the burner head, if
required.
CAUTION
• Do not wash any burner parts in a dishwasher.
• Do not use steel wool or scouring powders to clean the burners.
Brass burner head
(Only NA30K7750T*/NA36K7750T*)
NA9300K_DG68-00842A-01_EN+MES+CFR.indb 21
NOTE
• The brass parts of your burner will change
color with use. However, this will not
affect performance. You can clean the
brass parts with a brass cleaner.
• After cleaning, confirm that the burner
port openings aren't plugged.

Burner bases

CAUTION
The burner bases cannot be removed for cleaning.
Make sure that no water gets into the burner bases and the brass gas orifices.
Wipe clean with a damp cloth. Be careful not to scratch, deform, or damage the
bases. Allow them to dry fully before using.
Electrode
Power burner base Round burner base
English 21
9/12/2016 11:24:37 AM