Warranty Conditions - CHAUFFAGE FRANCAIS E Série Guide D'installation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

EN
while in vertical position with the pipe down and wait until the water
is completely drained from the unit water tank.
WARNING! When draining the water out of the water tank all
necessary precautions must be taken to prevent damages from
flowing out water.
If the unit inlet pipe does not leak water you should contact the
nearest authorized service center to remove the particles clogging
the system (most frequently limestone).
Increasing the water pressure in the water tank of the appliance is
a result of non-compliance with the appliance installation and
usage requirements - mounting the appliance to operate under
pressure, block the hot water pipe outlet, irregular cleaning of the
limestone deposited in the areas with limewater, water freezing
etc. Replacing the safety valve membrane is not a warranty
obligation of the trader and/or manufacturer.
FAILURES
In cases when the heater does not heat water, check if it is correctly
connected to the mains, or if the power supply in the premise is not
cut off, or if the illuminated switch is not in position off, or if the water
flowing through the appliance is too little, or if the pressure in the
plumbing is not lower than necessary.
If none of the above listed possible causes is present, disconnect
the heater from the power supply, stop the water flow to the
appliance, and call the nearest authorized service company.
In case that with normal water supply and knob turned to its
maximum position and switched on power supply (mains and unit
key illuminated) from the winch or the shower apertures is leaking
water, and key buttons are glowing, IMMEDIATELY UNPLUG THE
APPLIANCE from both the power and the water supply networks.
IT IS FORBIDDEN to attempt appliance subsequent switch on.
Immediately contact the nearest authorized by the manufacturer
service company.
In case of failure of the power cord and plug of water heater models
"E41" and "E42", contact the nearest authorized by the
manufacturer service company as the cord with plug must be
replaced by the manufacturer, its service agent, or a person with
similar qualifications in order to avoid danger.
During the appliance usage and maintenance do not damage the
metal plate with its technical data and serial number. If you take it
from the appliance store it together with the warranty card because
this is the only way to identify the product you purchased.
WA R R A N T Y, WA R R A N T Y P E R I O D A N D

WARRANTY CONDITIONS

The warranty, warranty conditions, warranty period, warranty
validity for purchased appliance and service related manufacturer
or vendor liabilities during the appliance warranty period are listed
in the appliance warranty form. When buying the appliance the
warranty form must be filled and signed both by seller and buyer.
Keep the warranty form in a secure place.
In all instances shall be in force the applicable laws, regulations
and other legislation dealing with the rights and obligations of
consumer, seller and manufacturer, and their relationships related
to purchased water heater, its installation, use, servicing and
maintenance.
Warranty term is determined by seller and is in force only for the
geographical territory of the country.
Warranty is valid only if the appliance:
Is installed according to the requirements for installation and
џ
operation.
Is used only as per designed purpose and in accordance with
џ
the installation and operation manual.
Warranty consists of free of charge repair of all factory defects,
which may arise during the warranty term. Repair is performed by
service specialists, authorized by seller.
Warranty is not valid for damages, caused by:
Improper transportation
џ
Improper storage
џ
Improper usage
џ
Parameters of water, different from the admissible norms for
џ
quality of drinking water, and particularly if the composition of
chlorides is more than 250 mg/l; the electrical conductivity is
less than 100 μS/cm and pH is outside of 6,5-8 for water
heaters with enameled water tanks; the electrical
conductivity is more than 200 μS/cm for water heaters with
water tanks made of chrome-nickel steel.
Supply voltage, different than the unit's rated voltage.
џ
Damages due to freezing of water.
џ
Elemental perils, disasters and other force majeure
џ
circumstances.
Non observance of the installation and operation manual.
џ
In cases, when a non authorized person has tried to repair
џ
any kind of a defect.
In the above cases the defect will be repaired against relative
payment.
Warranty shall not apply to normal wear parts and components of
the device, parts that are being removed during normal use,
lighting and signal lamps and the like, changing the color of
external surfaces, change of shape, size and location of parts and
components that are exposed to impact and conditions that are not
considered normal use.
Lost profits, tangible and intangible damages caused by
temporary inability to use the device during its prevention and
repair shall not by covered by the warranty.
COMPLIANCE WITH THE REQUIREMENTS OF THIS
INSTRUCTION MANUAL IS A PREREQUISITE FOR SAFE
OPERATION OF YOUR PURCHASED PRODUCT AND IS
ONE OF THE WARRANTY TERMS AND CONDITIONS.
IT IS ABSOLUTELY PROHIBITED TO THE USER OR ANY
AUTHORIZED BY HIM PERSON TO UNDERTAKE ANY
C H A N G E S I N T H E P R O D U C T D E S I G N A N D
STRUCTURE. ANY FINDING OF SUCH ACTIONS OR
ATTEMPTS SHALL AUTOMATICALLY RENDER VOID ALL
WARRANTY LIABILITIES OF SELLER OR PRODUCER.
IN CASE OF NECESSITY FOR SERVICE SEEK ONLY
MANUFACTURER AUTHORIZED SERVICE COMPANIES
LISTED IN THE ANNEXED FORM.
THE MANUFACTURER PRESERVED HIS RIGHT TO
STRUCTURAL CHANGES WITHOUT NOTICE WHERE
SUCH SHALL NOT AFFECT PRODUCT SAFETY.
8
EN

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

E41E51E71E42E52E72

Table des Matières