CHAUFFAGE FRANCAIS E Série Guide D'installation page 4

EN
WARNING! Before installation and operation with the appliance, read carefully the present manual!
KEY SAFETY REQUIREMENTS
Before starting the installation of your appliance and its operation it
is compulsory to read carefully the text of the instructions booklet.
It is designed to familiarize you with the unit, with the rules for its
proper and safe use and the minimum activities necessary to
maintain and service it. Furthermore, you will need to provide this
guide for use by qualified persons who will install and repair the
ATTENTION! The water heater is intended for use only for domestic purposes in the
household and is used to heat water from common water supply network, which
composition and features comply with the specified values in water quality legislation.
ATTENTION! The water heater must be installed and used only in premises without
freezing temperatures, with normal fire security and in conditions satisfying its protection
level against water penetration. Otherwise, it shall damage the appliance and because it is
a violation of these instructions for installation and use it shall not be covered by the
manufacturer or retailer warranty obligations.
ATTENTION! Installation of the water heater and connection to the water supply network
should be performed only by qualified persons in accordance with the instructions in
present manual and local regulations in force. The water pressure in the water supply
system should be higher than 0.2 MPa and lower than 0.8 Mpa.
WARNING! It is FORBIDDEN to install the appliance to operate under pressure!
WARNING! IT IS PROHIBITED to clog the opening of the safety valve pipe! Fig. 2
ATTENTION! Installation of safety and other components provided by the manufacturer is
COMPULSORY! Installing different mixing knob is FORBIDDEN!
WARNING! To the mixing tap outlet is mounted ONLY the winch supplied in the delivery set.
WARNING! Water heaters are produced with an open outlet to the atmosphere and it is
absolutely PROHIBITED to connect their outlet pipe to the stop water tap or fittings. Failure to
comply with this requirement shall destroy the appliance!
ATTENTION! Connection of the water heater to the power supply network should be
performed only by qualified persons in accordance with the instructions in present manual
and local regulations in force. The appliance should be properly connected to the current-
carrying wires and the protection grid! DO NOT connect the appliance to the electrical
installation before filling its water tank up completely with water! Failure to comply shall
make the appliance dangerous and in such state its use is strictly forbidden!
WARNING! It is OBLIGATORY to connect the plug of the power cord of units „Е41" and „Е42"
ONLY to an upright and properly connected contact with protective plates type Schuco.
WARNING! In case of failure of the power cord, contact the nearest authorized by the
manufacturer service company as the cord must be replaced by the manufacturer, its service
agent, or a person with similar qualifications in order to avoid danger.
ATTENTION! IT IS COMPULSORY that in the premise electric circuit feeding the water
heater with power cord without plug is installed such a device, which in the conditions of
unit in case of malfunctioning. Installation and commissioning of
the unit is not a warranty obligation of the seller and/or
manufacturer.
Keep this guide in a suitable place for future reference.
Compliance with the rules helps for safety use of the appliance and
is one of the warranty terms and conditions.
4
EN