SCHOLTES HL 458 Prescriptions De Montage Et Mode D'emploi page 29

1. Place the template (supplied) on the ceiling directly
EN
above the cooktop, matching the centre of the
template (R1) with the centre of the cooktop (R2).
The sides of the template must be parallel to the sides
of the cooktop. Prepare the electrical connection.
Note: The side of the template with the wording
"FRONT" corresponds to the hood controls side.
Drill the holes indicated on the template, and insert the
plugs.
2. Prepare the support bracket, suitably adjusting the
length of the cables according to the following formula:
L (cm)= X-31-H+3
L = truss extension
X = distance between the ceiling and the bottom edge
of the hood
After finding the right length, secure the cables,
tightening the lock nuts with a spanner.
3. Apply the support bracket on the ceiling, passing
the cables for the electrical connection through the
middle hole.
Fix with 3 screws.
IMPORTANT! Detail support bracket is equipped with
a wire (yellow/green) which must be connected to the
earth of the household electrical system.
4. Fix the hood to the hooking brackets and secure
with 1 screw for each bracket (COMPULSORY
FIXING).
5. Adjust the position of the hood by means of the
adjustment screws.
6. Fix the lighting unit to the hood with 3 screws and
crescent-shaped washers.
Note: The inside rim of the lighting unit has chamfers
which must match the fixing places.
7. Mount the grease filters.
Apply the aesthetic tabs (press-on) to cover the hood
fixing rib points.
8. Insert the control rod in the special seat.
Note! Compulsory coupling direction, with release.
9. Fix the connection box to the support bracket on
the ceiling with 2 screws.
Carry out the electrical connection and secure the
cables with the cable clamp with 2 screws.
Fix the connection box cover with 4 screws.
Important!: Make sure the interconnection cable does
not touch the lamps and arrange the excess part using
the cable clamps located at the top of the hood.
Important! Replacement of the interconnection cable
must be carried out by the authorised after-sales
technical service.
10. Insert the cover between the support cables,
making sure they enter the special slots on the cover.
Important! Leave enough cable so that it passes easily
through the slot obtained in the cover.
Secure the cover with 3 grub screws already screwed
(or to be screwed) on the support bracket.
Note: The 3 fixing screws secure the cover by virtue of
the friction they exert on the cover itself, and therefore
must not be completely tightened.
29