Installation - SCHOLTES HL 458 Prescriptions De Montage Et Mode D'emploi

Installation

! It is important to conserve this booklet for
EN
consultation at any moment. In the case of sale,
cession or move, make sure it is together with the
product.
! Read the instructions carefully: there is important
information about installation, use and safety.
! Do not carry out electrical or mechanical variations
on the product or on the discharge conduits.
! Your hood is ready to be used in the filtering version.
Installation
Electrical connection
The mains power supply must correspond to the rating
indicated on the plate situated inside the hood. If
provided with a plug connect the hood to a socket in
compliance with current regulations and positioned in
an accessible area. If it not fitted with a plug (direct
mains connection) or if the plug is not located in an
accessible area apply a bi-polar switch in accordance
with standards which assures the complete
disconnection of the mains under conditions relating to
over-current category III, in accordance with
installation instructions.
Warning: Before re-connecting the hood circuit to the
mains supply and checking the efficient function,
always check that the mains cable is correctly
assembled.
! The company declines any responsibility whenever
these regulations are not respected.
26
The minimum distance between the supporting surface
for the cooking vessels on the hob and the lowest part
of the range hood must be not less than 50cm from
electric cookers and 70cm from gas or mixed cookers.
If the instructions for installation for the gas hob specify
a greater distance, this must be adhered to.
Expansion wall plugs are provided to secure the hood
to most types of walls/ceilings. However, a qualified
technician must verify suitability of the materials in
accordance with the type
wall/ceiling must be strong enough to take the weight
of the hood. Do not tile, grout or silicone this appliance
to the wall. Surface mounting only.
of wall/ceiling. The