Eurotops 40864 Mode D'emploi page 19

P 8550 / A5
When buzzer is on you can see the logo
4) Set the brightness
Vertically long press in the wave button for 5 seconds to enter into the menu setting.
Short press vertically in the wave button 2 times.
Default value is 0. This is auto mode. It will adjust brightness
automatically according to the sun light.
Turn up or down the wave button to increase/decrease parameter value
(from 1 to 5 for low bright to high bright or back to 0 for auto mode).
After adjustment, vertical long press 5 seconds to save and exit.
5) Set the speed unit
Vertically long press in the wave button for 5 seconds to enter into the
menu setting.
Short press vertically in the wave button 3 times.
Default value is 0. That means speed unit is km/h.
Turn up or down the wave button to increase/decrease parameter value
(0 is for km/h, 1 is for miles) .
After adjustment, vertical long press 5 seconds to save and exit.
6) Set the Power on/off voltage
Vertically long press in the wave button for 5 seconds to enter into the
menu setting.
Short press vertically in the wave button 4 times.
Default value is 100. That means your device will turn on when you start
the engine and will turn off when you shut down your engine.
If HUD cannot automatically turns off, please adjust the voltage to
13.2V-14V turning up or down the wave button to increase/decrease
parameter value (from 100 to 150).
After adjustment, vertical long press 5 seconds to save and exit.
7) Display mode
Vertically long press in the wave button for 5 seconds to enter into the
menu setting.
Short press vertically in the wave button 5 times.
Default value is 0. That means the display is reflect on the windshield.
Turn up or down the wave button to increase/decrease parameter value
(0 is reflect on the windshield,1 can directly see from the sit-up HUD
screen).
After adjustment, vertical long press 5 seconds to save and exit.
8) Reset setting:
Long pull up the wave button, and when all the LED light up, it means HUD finish the restore factory setting
on the screen.