Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2 - Multimedia interface description
2.3 - Rear view
01 – A/V OUT: audio/video output for the connection of an external multimedia receiver (e.g.:
TV, monitor).
02 – D–SUB OUT: connector for the connection of a monitor with D–SUB input.
Note: the signal found on this connector is in the PAL 720x576 format.
03 – A/V IN: audio and video input for the connection of an external source.
04 – MIC–IN: external microphone input (setting for future applications).
05 – USB Slave: Mini USB connector for connection to a PC for firmware update, configuration
and diagnostics.
06 – Serial connector: RS–232 serial connector for connection to a PC for firmware update, con-
figuration and diagnostics through 0492 34.
07 – Reset: RESET key.
08 – Power Supply: VAC power supply (100Vac – 60Hz and 240Vac – 50 Hz).
09 – USB Master: USB connector for connection to devices such as mp3 players (setting for future
applications).
10 – SCS A/V OUT: connector for connection to the Legrand "SCS Video 2 wire bus".
11 – DC–OUT: Constant 12Vdc voltage output (setting for future applications).
12 – IR TX: Connectors for the connection of infrared transmission cables.
13 – SCS A/V IN: Connector for connection to the Legrand "SCS Video 2 wire bus".
14 – ETH: Ethernet RJ45 Connector for connection to a TCP/IP network, compatible with a 10/100
Mbps speed.
22
1
A/V OUT
SCS
ETH
IR-TX1
A/V IN
14
13
12
IR LED
2
3
A/V IN
SCS
IR-TX2
A/V OUT
12
11
10
System LED
4
5
6
9
Ethernet network
operation LED
7
8
Publicité
Chapitres
Table des Matières
