Maintenance Instructions; Moving And Storage Instructions - Schumacher Electric BE01253 Manuel D'utilisation

POWERING A 12V DC DEVICE
5.4
The unit is a power source for all 12V DC accessories that are equipped with a 12V accessory plug. Use it for
power outages and on fishing or camping trips.
NOTE: Do not power a 12V device with the unit while charging the internal battery.
1. Make sure the device to be powered is OFF before inserting the 12V DC accessory plug into the 12V
DC accessory outlet.
2. Open the protective cover of the DC power outlet on the unit.
3. Plug the 12V DC device into the DC power outlet and turn on the 12V DC device (if required).
4. When finished, turn off the DC device (if required) and unplug from the DC power outlet.
CAUTION: Do not use the unit to run appliances that draw more than 15A DC.
NOTE: Extended operation of a 12V DC device may result in excessive battery drain. Recharge the unit
immediately after unplugging the 12V DC device.
Estimated run-times
APPLIANCE TYPE
Cell phone
Fluorescent light
Radios, fans
Depth finder
Camcorder
Electrical tool
Electric cooler
Car vacuum, air compressor
NOTE: Actual time may vary. Times are based on the internal battery being fully charged.
6.

MAINTENANCE INSTRUCTIONS

After use and before performing maintenance, unplug and disconnect the jump starter.
6.1
6.2 Use a dry cloth to wipe all battery corrosion and other dirt or oil from the battery clips, cords and the
jump starter case.
Ensure that all of the jump starter components are in place and in good working condition.
6.3
All servicing should be performed by qualified service personnel.
6.4
7.

MOVING AND STORAGE INSTRUCTIONS

Store inside, in a cool, dry place.
7.1
Do not store the clips on the handle, clipped together, on or around metal, or clipped to cables. The clips
7.2
on the jump starter are live when the switch is in the ON position and will produce arcing or sparking if
they come in contact with each other. To prevent accidental arcing, always place the switch in the OFF
position and keep the clips on the storage holders when not using it to jump start a vehicle.
If the jump starter is moved around the shop or transported to another location, take care to avoid/
7.3
prevent damage to the cords, clips and jump starter. Failure to do so could result in personal injury or
property damage.
IMPORTANT: Do not use and/or store the jump starter in or on any area or surface where damage
could occur if the internal battery should unexpectedly leak acid.
IMPORTANT:
7.4
• CHARGE IMMEDIATELY AFTER PURCHASE
• KEEP FULLY CHARGED
Charge the jump starter's internal battery immediately after purchase, after every use and every 30 days.
All batteries are affected by temperature. The ideal storage temperature is at 70°F. The internal battery will
gradually self-discharge (lose power) over time, especially in warm environments. Leaving the battery in a
discharged state may result in permanent battery damage. To ensure satisfactory performance and avoid
permanent damage, charge the internal battery every month.
EST WATTAGE EST USAGE
4 watts
4 watts
9 watts
9 watts
15 watts
24 watts
48 watts
80 watts
• 8 •
13 hrs
15 hrs
6.7 hrs
6.7 hrs
4 hrs
2.5 hrs
1.3 hrs
0.8 hrs