Switching On And Off - RDM PRO 70007 Notice D'utilisation

TIPS:
· The battery pack must be charged before using your machine for the first time. The
battery pack reaches its full capacity only after several charges.
· Avoid fast and consecutive battery charges. Do not recharge after using only briefly. Use
the tool for at least 15 minutes before starting a new recharge.
· The battery pack and the power supply unit become hot during the charging process.
This is not a malfunction.
INSERTING DRILL BITS/SCEWDRIVER BITS
1) In order to insert a drill bit/screwdriver bit,
grasp the back section of the chuck and
rotate the front section of the chuck until the
drill/bit holder is fitted.
2) Insert the tool as far as it will go into the
chuck opening.
3) Clamp in the screwdriver bits using the
bit-holder, which is part of the range of

SWITCHING ON AND OFF

Set rotation direction switch to desired
position.
-To switch on: press ON/OFF switch
-To switch off: release ON/OFF switch
By drilling with lowest rotation speed for a long time, crease the danger of the
overheating of the motor. Please use often coolant time (Internal) approx. 15 Minutes.
CAUTION:
Before use checks the direction of the rotation. Change direction of rotation only
when machine is not in operation.
VARYING THE SPEED
Simply apply pressure onto the On-Off/Switch by squeezing it in, this will increase the
speed and
releasing the pressure on the On-Off/Switch will decrease the speed.
accessories.
4) Select screwdriver bits appropriate to the
screw head in order to avoid damage to
screw heads.
5) Firmly tighten the chuck by hand. Check
whether the tool is firmly seated in the drill
chuck.
1
1. Front section of the chuck
2
2. Back section of the chuck
FORWARD & REVERSING SWITCH
Set rotation direction switch either to
R (clockwise) or to opposite side ( anti-
clockwise). (When ON/OFF switch is
activated, rotation direction switch is
locked). Anti-clockwise rotation is suitable
for e.g. loosening screws and nuts.
1
2
1. Direction reversal switch
2. ON-OFF switch with speed control