8.3 Operating modes
The safety relay can be switched to different operating modes using the "mode" rotary switch.
Setting the operating mode:
•
Switch off the supply voltage
•
Open the cover on the front of the safety relay
•
Set the desired operating mode using the "mode" rotary switch
•
Close the cover
•
Switch on the supply voltage
If the "mode" rotary switch is adjusted during operation, the safety relay will go into a malfunction state
until the supply voltage is switched off and on. The same applies if no operating mode is selected
(rotary switch in vertical position).
Operating mode
Automatic or manual
start
Without detection
of shorts across
contacts
With detection of
shorts across
contacts
© Festo Didactic 8114184
Monitored start rising
Monitored start falling
edge
edge
Safety Relay EduTrainer
Automatic start
with startup test
®
41