Configuring The Webcam - VHF N4+ Mode D'emploi D'origine

N4+ – Installing the machine
5.8 Configuring the w ebcam
In the following cases, you need to configure the
webcam of the machine:
First installation of the machine
n
Exchange of the CAM computer
n
Exchange of the control unit
n
Exchange of the webcam
n
1. Open the DENTALCNC Application settings with the
following icon in the main icon bar:
2. Open the General settings with the following icon in
the local icon bar:
3. Select the following icon next to the Webcam selec-
tion label:
A window opens.
4. Select the webcam SMI from the drop-down list at
the top of the window.
F . 25 S
IG ELECTING THE CORRECT WEBCAM
Original Operating Instructions: N4+
Version: 12/16/2021
The current still image of the webcam displays.
F . 26 E : W
IG XAMPLE EBCAM IMAGE
5. Select the depicted icon:
The window closes. The webcam configuration is
saved to the CAM computer.
EN 25