Binding; Main Screen; Steering Dual Rate (St. D/R) - ETRONIX PULSE EX3GPRO Manuel D'instructions

7. Binding

Transmitter/Receiver Binding
1. Turn on the transmitter while holding down the '3CH' button located on the hand
grip. Release the button when the LED on the transmitter starts flashing blue and you
hear a beeping noise. The transmitter is now in it's binding mode.
2. Turn on the receiver. The LED on the receiver will be flashing green slowly. Place the
transmitter next to the receiver then press the 'Bind' button on the receiver until you
see the green LED on the receiver flash rapidly then return to a slow flash. Release the
button on the receiver.
3. Turn the transmitter off then switch it back on again; the LED on the receiver should
become solid green. The binding process is now complete.

8. Main Screen

9. Steering Dual Rate (ST. D/R)

The dial marked 'ST D/R' on the transmitter controls the amount of servo travel. Turn-
ing the dial clockwise gives more travel and turning it anti-clockwise gives less travel.
5