Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
FEATURES:
1. This high performance 180cm Mist Fan has an Epoxy coating to preserve against
corrosion.
2. The misting and blowing is a combination of two different electric motors. High quality
bearings keep a stable performance, moderate temperature, low noise and continuous
usage.
3. With an advanced misting system, the mist volume can be adjusted. The water pump and
float switch will cut out when the water supply has been reduced to the minimum level for
operation.
4. Misting time will last up to 10 hours (it depends of the mist volume).
5. The trolley makes this fan easy to move.
USAGE:
See overleaf for a drawing of the assembly instructions.
Open the water tank cover, fill the tank with clean water and then close the cover.
Connect the fan and water pump switches and then connect the power supply. You can
also asjust the mist level if required.
The speed switch reads as follows:
In attachement to setting '2' (medium), you will see a pucker handle. When using it, press
the button in the handle to open, then repress the handle.
To adjust the oscillation, please wait for the blade to stop, and then disconnect the power
. Please note: the fan will not oscillate if the adjusting screw is set at the centre hole of the
oscillating fixture.
'0'
OFF
'1'
LOW
'2'
MEDIUM
'3'
HIGH
Publicité
Table des Matières
