Hkoenig KB14 Manuel D'utilisation page 6

Step 3. Open the lid and take out the ice basket to add appropriate water into water reservoir.
Note: The water poured into water reservoir should be lower than the water reservoir's MAX
position. When water volume goes beyond the max, please open the bottom water
drain plug to drain the spare water out. Then close the transparent lid.
Step 4. Select the desired ice size, the default size of machine is large one.
Note: Please select the (S) when ambient temperature is
below 15°c.When the ambient temperature is higher than
30°C, Large ice cube sizes are recommended.
Note: For the first three cycles, the ice may be small and irregular in size.
Note: When the ice collecting tray is full please remove the
ice immediately, Do not allow the ice collecting tray to overfill.
CLEANING & USE GUIDANCE ：
1. Clean the inner liner, ice collecting tray, water box, ice
shovel and evaporator frequently. When cleaning, unplug
the unit and remove the ice cubes. Use a diluted solution
of water and vinegar to clean the inside and the outside
surface of the Ice maker. Do not spray Ice maker with
chemicals or diluted agents such as acids, gasoline or oil.
Rinse thoroughly before starting.
2. Keep ventilation openings in the appliance enclosure, or
in the built-in structure, clear of obstruction. Do not use
mechanical devices or other means to accelerate the
defrosting process, other than those recommended by
the manufacturer.
3. Reuse the machine after being idled for a period of time,
it may not have enough water to pump for air retard, and
the indicator of "ADD WATER" will keep lighting. At this
time, you just need to press POWER button again, the
machine can enter normal state.
4. To ensure the cleanness of ice, please change water for
water reservoir at least once one day. If do not use for a
long time, please drain the water out and clean it up.
5. If the compressor takes a strike action for shortage water,
fully water or interruption of power supply, it will delay for
3mins to start up after restarted.
6. Always use fresh water before starting ice production
either at initial installation or after a long shut-off period.