Care & Cleaning; Technical Specifications - Inventum MT60 Mode D'emploi

Clean the sensor tip after every use. Use a clean cloth or cotton bud that can be moistened with disinfectant, alcohol or warm water.
To clean the entire device, use a soft cloth slightly moistened with a mild soapy solution. Water must never get into the device. If water gets into
the
device, remove the battery immediately. Only use the device again when it is completely dry. Do not use any harsh cleaning agents.
Never immerse the device in water. Always store the thermometer with the cap on in order to protect the sensor.
The device must not be stored or used at too high or low a temperature or humidity (see technical specifications), in sunlight, in association with
an
electrical current or in dusty locations. Otherwise, inaccuracies can occur. If prolonged storage is intended, you should remove the battery.

Technical Specifications

Note: When the device is used outside the specifications, perfect functioning cannot be guaranteed. We reserve the right to make technical
changes to improve and develop the product.
Measurement range
Laboratory measurement precision Forehead thermometer mode: ±0,3°C (±0,5°F) from 34°C to 42,2°C (93,2°F - 108°F)
Interval between 2 measurements
Measurement units
Ambient operating conditions
Storage conditions
Dimensions
C A R E & C L E A N I N G
Forehead thermometer mode: 34°C - 42,2°C (93,2°F - 108°F)
SCAN mode: -22°C - 80°C (-7,6°F - 176°F)
SCAN mode: ±0,3°C (±0,5°F) from -22°C to 42,2°C (71,6°F - 108°F)
±2°C (±4°F) from >42,2°C <22°C(>71,6°F - <108°F)
At least 5 seconds
°Celsius (°C) or °Fahrenheit (°F)
10°C to 40°C (50°F - 104°F) with a relative humidity of 95% (non-condensing).
-20°C to 50°C (-4°F - 122°F) with a relative humdity of up to 95% (non-condensing).
34 x 145 x 28 mm
39