During Use; Forehead Measurement - Inventum MT60 Mode D'emploi

Used batteries should not go into domestic refuse. You are legally obliged to dispose of the batteries correctly. Dispose of them through your
electrical dealer or local recycling centre.
Note: you will find these symbols on batteries containing toxic substances: Pb = battery contains lead, Cd = battery contains cadmium, Hg =
battery contains mercury. The battery in this device does not contain toxic substances.

During use

Always ensure that the sensor is clean and undamaged. Switch on the thermometer with the " " button.
Forehead measurement
After a short self-test and two short beeps, the thermometer is ready for measuring the temperature at the forehead/temple. The infrared
thermometer is in 'forehead thermometer'. This is indicated by the symbol .
Note that
- the thermometer must have been at least 30 minutes in the room in which the measurement is made,
- the measuring result may be falsified by physical activity, fundamentally increased sweat formation on the forehead, consumption of
vasoconstrictive medications and skin irritations.
- the forehead or temple must be free of sweat and cosmetics.
Apply the thermometer to the left or right tempe and press the "SCAN" button. Move the thermometer to and over the temple.
During the measurement you can hear short beeps signalling that the thermometer has found a new maximum temperature.
The end of the measuring time is signalled with a long beep. Release the "SCAN" button. You can now read off the
temperature measured. The LED is also illuminated according to the test result: a green LED indicates that body temperature
is within the normal range, but a red LED lights up with measured values over 37,5°C, i.e. it is a fever alarm.
The measurement normally takes from 5 to 8 seconds, but can take up to 30 seconds.
The thermometer signals with two short beeps and a no longer flashing forehead symbol that the thermometer is ready for a new measurement.
36