Fell Marine MOB+ xHUB BU90115 Manuel Utilisateur page 14

In the event you as the driver need to exit the boat while mooring
or performing other tasks you can engage Moor Mode. MOB+ will
be in standby for 2 minutes, allowing you to go out of wireless
range without the engine stopping.
1.
2.
3.
4.
5.
6.
NOTICE
14
Moor Mode
Engage Moor Mode
Start with being connected to the xHUB with
your xFOB.
Press & Hold the button on the xFOB for at
least 3 seconds.
The xHUB will flash a yellow light and sound a
signal every 2 seconds. You are now in Moor
Mode.
The Moor Mode will time-out after 2 minutes.
If you are within wireless range of your xHUB
the system will automatically reconnect to the
xFOB. If you are outside the range (normally 30
feet (10 m) or more)of your xHUB, the system
will shut down the engine to prevent the engine
from running unintentionally.
Exit Moor Mode by clicking once on the xFOB
while Moor Mode is active and your xFOB is
within 30 feet (10 m) from your boat. This will
disconnect the system.
The Moor Mode assists you as the driver when in
need to go out of range, but still need to have
the engine running. This can be very helpful when
operating a boat alone, and in the need to do
cordage back and forth while mooring. In the
event that you would fall overboard while in Moor
Mode, the system will stop the engine after 2
minutes or if Moor Mode times out.