Onda OVS Notice D'utilisation page 12

4. MOVEMENT AND TRASPORTATION
The ONDA Oil Separators are delivered on wood pallets or crates. In conformity with the laws in
force in your country, the packaging material must be recycled or treated as waste material.
LIFTING AND TRANSPORTATION MUST ALWAYS BE DONE BY
EXPERT PERSONNEL
.
Verify on the catalogue the dimensions and the weight of the Oil Separator in order to choose a
suitable system of lifting.
An harness - of steel, chain or synthetic fibre - resistant to the load to move, can be used (see
appendix 12.1 for the location of the centre of gravity CG).
Oil Separators have connections leaning from the equipment. We recommend, therefore, to be
careful during the moving not to lead to damages to the leaning parts.
Before moving, be sure the paths inside the building are suitable to the dimensions of the
pressure equipment.
ATTENTION: DO NOT MOVE THE EQUIPMENT UNDER PRESSURE
5. STORE
The Oil Separator must be stored preferably indoors.
If the Oil Separator is stored (see 5.1) outside the sunlight and the cooling during the night time
may cause the formation of damp inside the equipment and of the plastics of the package, if
present.
Internal parts, at any rate, are protected by plastics plugs. Before storing make sure a plug is fitted
onto each connection.
5.1 Rust prevention
The ONDA Oil Separators ' external surface is protected by a rustproof primer.
This type of painting is igroscopic and must be completed with a final treatment. It is suitable to
any commercial finishing painting and adhesive for possible isolations To avoid, therefore, the
formation of rust preserve the ONDA Oil Separator from the atmospheric agents or protect it with
special finishing painting.
6. INSTALLATION
IT IS FORBIDDEN THE USE OF PRESSURE EQUIPMENT TO
PEOPLE NOT DUTY INSTRUCTED
After unpacking be sure of the integrity of the pressure equipment; do not use in case of doubt
and contact ONDA Spa.
Installation must allow maintenance and clearness.
In case of outdoor installation (see 5.1), protect the pressure equipment from accidental impacts
Install the Oil Separator in vertical position.
12