Maintenance; When It Is Difficult To Attach The Pads; How To Clean And Store - Omron E2 ELITE Mode D'emploi

Neurostimulateur électronique
Masquer les pouces Voir aussi pour E2 ELITE:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 18
HV-F127 manual.book Page 14 Monday, December 29, 2014 3:34 PM

3.Maintenance

3. Maintenance

3.1 When it is difficult to attach the pads

Wash the Pads when the adhesive surface becomes
dirty and the Pads are difficult to attach.
– Wash the Pads after every thirty uses. Pads can be
washed approximately ten times.
– Pads are consumables. Purchase the optional Pads
when the adhesive surface is damaged. (Refer to
page 17.)
* The life of Pads may vary by the frequency of wash,
skin condition, and storage state.
Turn off the power, then remove the Electrode Cord from
1.
the Pad.
Wash the Pad softly with
2.
your
fingertips
under
slow running cold water
for several seconds.

3.2 How to clean and store

How to clean the Unit
• Keep the unit clean all the
time.
• Be sure to turn off the Power
and remove the Electrode
Cord from the Main Unit
when cleaning the unit.
• Wipe off stains on the Main
Unit with a soft cloth.
• If the unit is heavily stained, wipe it with a cloth moistened
with water or detergent. Wipe off the unit with a dry cloth.
* Be careful so that no water should get into the Main Unit.
14
Sufficiently dry the Pads and let
3.
the adhesive surface airdry.
* Do not wipe the adhesive sur-
face with a tissue paper or a
cloth. If a tissue paper is
adhered to the adhesive sur-
face by accident, do not try to
peel it off. Instead, moisten the
tissue paper with a small
amount of water, and then it
will come off easily.
Lightly attach the Pad to the
4.
Electrode Holder for storage.
(Refer to page 13.)
General advice from OMRON on the handling of Pads
• Do not use hot water, detergent, or chemicals such as
thinner or benzine.
• Do not scratch the adhesive surface with your nail or a
brush.
• Do not wash the Pads too long or too frequently.
• Do not store the Pads under high temperature, high
humidity, and direct sunshine.
* The adhesive surface may be damaged and the Pads
may last shorter.
* If the adhesive surface becomes sticky or the Pad
peels off, leave the Pad in the refrigerator (do not
freeze) overnight. The adhesion may be restored.
Notes on care and storage
• Do not use benzine, thinner, or
gasoline to clean the unit.
• Do not store the unit under high
temperature, high humidity, and
direct sunshine, or where there is a
lot of dust and/or corrosive gas.
• Keep the unit out of reach of
children.
• If you are not going to use the
unit for more than three
months, store the unit after
removing the batteries.
* If you do not observe the
above-mentioned notes or
correct use of the unit,
OMRON cannot take respon-
sibility on quality of the unit.
Gasoline
Thinner

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Hv-f127-e

Table des Matières