GE PT920 Mode D'emploi page 44

Before you call for service...
Troubleshooting Tips
Problem
Display "wakes up"
without touching it
"F— and a number
or letter" flash
in the display
Display goes blank
Display flashes
"PROBE" appears in
the display
Power outage,
clock flashes
Steam from the vent
"Burning" or "oily"
odor emitting from
the vent
Strong odor
Fan noise
44
Possible Causes
The Display is equipped with
a sensing technology that will
"wake up" when you (your hand)
approaches the Touch Screen.
The display is sensitive and may
"wake up" when lights are turned
on or due to the movement
of nearby people or objects.
You have a function
error code.
If the function code repeats. • Disconnect all power to the oven for at least 30
A fuse in your home may
be blown or the circuit
breaker tripped.
The clock is in the
black-out mode.
Power failure.
This is reminding you to
enter a probe temperature
after plugging in the probe.
Power outage or surge.
When using the convection
feature, it is normal to see
steam coming out of the
oven vent. As the number
of racks or amount of
food being cooked increases,
the amount of visible steam
will increase.
This is normal in a new oven • To speed the process, set a self-clean cycle for a
and will disappear in time.
An odor from the insulation
around the inside of the
oven is normal for the first
few times the oven is used.
A cooling fan or a convection • This is normal. The cooling fan will turn on
fan (depending on the
function you are using)
may automatically turn on.
What To Do
• The Display should return to its standby mode after
10 minutes if no further interaction occurs.
• Touch the CLEAR/OFF pad. Allow the oven to cool for
one hour. Put the oven back into operation.
seconds and then reconnect power. If the function
error code repeats, call for service.
• Replace the fuse or reset the circuit breaker.
• See the Options–Settings section.
• Reset the clock.
• Enter a probe temperature.
• Reset the clock. If the oven was in use, you must reset
it by touching the CLEAR/OFF pad, setting the clock
and resetting any cooking function.
• This is normal.
minimum of 3 hours. See the Using the self-cleaning
oven section.
• This is temporary.
to cool internal parts. It may run for up to 1-1/2
hours after the oven is turned off. The convection
fan will cycle on and off until the function is over
or the door is opened.