Installation - Aglient Turbo-V 2300 TwisTorr Mode D'emploi

16 Instructions for Use

Installation

Installation

Cause its weight, the pump must be handled by means of suitable moving and
WARNING!
handling tools. Use the suitable handling kit eyebolts screwed into the holes
of the pump body.
WARNING! The power cord of the controller is defined as disconnecting device in order to
remove the power from the pump and the controller in case of an emergency.
Make sure the power connector of the instrument can be easily reached and
unplugged. Provide sufficient space behind the power socket of the controller
to unplug the cable.
If the controller cannot be installed in the system, so that the power cord can
be easily reached, a different option has to be installed to disconnect the
controller from mains.
Power supply cord: The correct cable for electrical wiring is a three wires (Ph+N+Earth) cable. The
wire section has to be at least 0.75 mm
Do not remove the bolted cap before connecting the turbopump to the system.
CAUTION!
Remove connector protections only after fixing the turbopump to the system.
CAUTION!
232/262
(AWG18).
2
Turbo-V 2300 TwisTorr Pumps User Manual / 87-901-017-01 (C)