Publicité
Les langues disponibles
Les langues disponibles
1. Loading Packs
Loading the machine is easy. Release the latch and open the cabinet door.
Remove used pack and clean interior if necessary. Open the pack as instructed
on the carton. Place the full pack back in the cabinet with the dispense tube
facing downwards at the front of the machine. Feed the dispense tube down
through the pinch tube valve by pushing the operating lever. (See diagram
below)
Note:
The dispense valve assembly can be slid forward to make this operation easier
if required. When the tubing is fully through the valve, release the operating
lever and slide the pack into the cabinet. Make sure the tube is not kinked.
Close and latch the door and cut the sealed end of the dispense tube.
2. Cleaning
Wash the drip tray daily, or when full, in warm soapy water. The dispense valve
assembly may be completely immersed in warm soapy water for cleaning
whenever convenient. At regular intervals the interior of the machine should be
wiped with a damp cloth and buff dried with a lint-free cloth. The exterior may be
cleaned by the same method.
03
Publicité
