etp HYLOC Série Notice D'utilisation page 6

mountInG
axial/radial connection
1a. When delivered, ETP-HYLOC is prepared for
axial (a) connection (where the quick
connections are mounted).
1b. If radial (r) connection is to be made, remove
the steel plugs and mount these in the 3 axial (a)
ports.
ImPortant: The steel plugs must be tightened to
20 Nm using a torque wrench. The hex key is 5 mm.
1a
6
Cleaning
2. Clean the shaft, hub, all interior and exterior
contact surfaces of ETP-HYLOC thoroughly with a
solvent.
note: If there is any grease on these surfaces it
may cause the joint to slip.
1b