Safety Regulation - etp HYLOC Série Notice D'utilisation

safety regulation

Read this Instruction manual through carefully in
order to familiarize yourself with the safe and
efficient operation of this product. Keep this
handbook for reference purposes. This Instruction
manual contains important instructions and
directives for the safe and proper operation of the
product.
Working with high pressure
All accessories that are connected to ETP-HYLOC,
such as pump, connections, hoses and other
accessories must be designed for a working
pressure that is at least equal to the maximum
pressure that is needed for ETP-HYLOC.
Do not use incorrect/faulty accessories when
working with high pressures.
Do not overtighten connections/fittings. It is better to
re-tighten if a slight leakage occurs than to damage
the threads by overtightening.
Protection glasses should be worn
at all times when
mounting/dismantling ETP-HYLOC.
Handling
Please handle ETP-HYLOC carefully when moving
or mounting/dismantling from the machine as it is a
high precision unit. Always make sure all contact
surfaces are clean and free from impurities.
Should ETP-HYLOC be difficult to handle or extract,
the extra threads in the flange could be used for
ease of handling and/or extraction.
M8/M12/M16 threads, depending on ETP-HYLOC
size.
note:
Never pressurise ETP-HYLOC without hub and shaft
mounted. To pressurise an unmounted ETP-HYLOC
may destroy it.
oil for the pump
The oil for the pump should be transmission oil type
sae 80 W.
safety reGulatIon
5