Environment Concerns; Installation - Zanussi ZDI121 Mode D'emploi

Electrical connection - Voltage -
Overall power - Fuse
Water supply pressure
Capacity

Environment concerns

The symbol on the product or on its packaging
indicates that this product may not be treated as
household waste. Instead it should be taken to the
appropriate collection point for the recycling of electrical
and electronic equipment. By ensuring this product is
disposed of correctly, you will help prevent potential
negative consequences for the environment and human
health, which could otherwise be caused by inappropriate
waste handling of this product. For more detailed
information about recycling of this product, please
contact your local council, your household waste disposal
service or the shop where you purchased the product.
The packaging materials are environmentally friendly and
can be recycled. The plastic components are identified by

Installation

Warning! Make sure that mains plug is
disconnected from the mains socket during
installation.
Important! Obey the instructions in the enclosed template
to:
• Build-in the appliance.
• Install the furniture panel.
• Connect to the water supply and drain.
Install the appliance under a counter (kitchen worktop or
sink).
If a repair is necessary, the appliance must be easily ac-
cessible for the engineer.
Put the appliance adjacent to a water tap and a drain.
For the venting of the dishwasher only water fill, water
drain and power supply cable openings are necessary.
Information on the electrical connection is given on the rating plate on the
inner edge of the dishwasher door.
Minimum
Maximum
markings, e.g. >PE<, >PS<, etc. Discard the packaging
materials in the applicable container at the community
waste disposal facilities.
• Pull the mains plug out of the socket.
• Cut off the mains cable and mains plug and discard
• Discard the door catch. This prevents the children to
The dishwasher has adjustable feet to allow the adjust-
ment of the height.
Make sure that the water inlet hose, the drain hose and
the supply cable are not kinked or squashed, when you
insert the machine.
Attaching the appliance to the adjacent units
Make sure that the counter below which you attach the
appliance is a safe structure (adjacent kitchen units, cab-
inets, wall).
Adjusting the level of the appliance
Make sure that the appliance is level to close and seal the
door correctly. If the level of the appliance is correct, the
door does not catch on the sides of the cabinet. If the door
does not close correctly, loosen or tighten the adjustable
feet until the appliance is level.
0,05 MPa (0,5 bar)
0,8 MPa (8 bar)
12 place settings
Warning! To discard the appliance, follow the
procedure:
them.
close themselves inside the appliance and endanger
their lives.
29