Replacing Injectors; Intended Use; Lighting The Burners - Franke FHMA 604 3G DC Mode D'emploi

FHMA 604 3G DC / FHMA 755 4G DC/DCL / FHMA 905 4G DCL / FHSM 604 3G DC

Replacing injectors

Not supplied injectors must be requested to
the customer service.
Important: All the appliances are factory-set
for natural gas (G20). If a different type of gas
is to be used, change the injectors as follows:
– Remove the grids, burner caps and flame-
spreaders;
– Unscrew the injectors and replace them
with those provided and suitable for the
gas supply, making sure the marking
matches that given in the table;
– Refit the flame-spreaders, burner caps
and grids.
These burners do not require air adjustment.

INTENDED USE

CAUTION: This appliance is for cooking
purposes only. It must not be used for other
purposes, for example room heating.
Z
Do not pull the appliance or the power
cable to unplug it.
Z
Close the general gas supply cock when
the hob is not in use.
Risk of burns!
Z
Do not touch the pot grids during use.
Z
Do not touch the appliance with wet parts
of the body.
FHSM 604 4G / FHSM 755 4G DC / FHSM 905 4G DCL
ø
7
Accessing the hob
To access the tray containing the functional
parts, proceed as follows:
– Remove the grids, burner caps and flame-
spreaders;
– Remove the knobs, sliding them off their
pins;
– Remove the screws that fix the burners to
the hob;
– Lift the hob.
Important: When converting the appliance to
a different type of gas, place the corresponding
sticker (supplied as an accessory) in the
special space on the data plate. For operation
with LPG (G30 or G31), the minimum flame
adjustment screw must be fully screwed down.
These appliances are supplied in cat. II 2H3+.

Lighting the burners

The hob is lit with the control knobs. To light
the burners, proceed as follows:
– Press and turn the required knob to the
lighting and max delivery position.
– Keep the knob pressed down for
3-4 seconds to allow the sparks to ignite
the gas coming out the burner and to allow
the thermocouple to heat up.
Then release the knob and, turning it
anticlockwise, adjust the flame as required.
If the flame does not stay lit, repeat the
operation from step 1.
– 9 –
EN