Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
• To stop the machine, release the on/off switch (2).
Adjusting the base plate (Fig. B)
Due to its movability, the baseplate (7) angle
adapts to the workpiece. Furthermore, the length
of the baseplate can be adjusted depending on the
required sawing depth.
1. Loosen the baseplate bolts (11) using the hex
key (10) provided.
2. Adjust the baseplate (7).
3. Tighten the baseplate bolts (11) using the hex
key (10) provided. It is possible to store the hex
key onto the machine, as shown on Fig. B.
Plunge cutting (Fig. D)
Plunge cutting may only be used on soft materials
such as wood, aerated concrete, gypsum plaster
boards, etc. However, this requires a certain practi-
se and is only possible with short saw blades.
1. Place the saw onto the workpiece and switch it on.
2. Ensure that the bottom edge of the footplate
rests on the workpiece surface as shown.
3. Slowly saw into the workpiece at an angle, mo-
ving the saw to a vertical position and continue
to saw along the cutting line.
4. Switch the saw off and lift off the workpiece
when the work is complete.
Flush cutting (Fig. E)
Elastic bi-metal saw blades allow you to saw
protruding objects (e,g, water pipes, iron bars, etc,)
nearby the wall.
1. Apply the saw blade directly to the wall and
bend slightly so that the footplate rests against
the wall. Pay attention that the saw blade
always extends beyond the diameter of the
material being worked.
2. Switch the machine on and saw off the workpiece
keeping constant lateral pressure against the wall.
Optimum use
• Adjust saw blade and stroke rate to suit the ma-
terial to be processed. For right radius curves it
is best to use a narrow saw blade. Apply coolant
or lubricant to deal with the fluttering produced
along the cut line when sawing metal.
• Check wood, chip boards, building materials
etc, for hard materials (nails, screws etc.), befo-
re sawing and remove them, if necessary.
• Clamp material well. Do not support the workpie-
ce with hand or foot. Do not touch objects or the
10
floor with the saw running (danger of backlash).
• Put the footplate on the surface of the workpie-
ce, and saw through it with constant contact
pressure or feed. If the saw blade seizes switch
the machine off immediately. Spread the gap
with a suitable tool and pull out the saw blade.
• After finishing work, switch off the machine and
only put down after it has come to a complete
standstill.
5. MAINTENANCE
Before cleaning and maintenance, always
switch off the machine and remove the
battery pack from the machine.
Clean the machine casings regularly with a soft
cloth, preferably after each use. Make sure that the
ventilation openings are free of dust and dirt. Re-
move very persistent dirt using a soft cloth moiste-
ned with soapsuds. Do not use any solvents such
as gasoline, alcohol, ammonia, etc. Chemicals such
as these will damage the synthetic components.
ENVIRONMENT
Faulty and/or discarded electrical or
electronic apparatus have to be collected at
the appropriate recycling locations.
Only for EC countries
Do not dispose of power tools into domestic waste.
According to the European Guideline 2012/19/EC
for Waste Electrical and Electronic Equipment and its
implementation into national right, power tools that
are no longer usable must be collected separately
and disposed of in an environmentally friendly way.
WARRANTY
VONROC products are developed to the highest
quality standards and are guaranteed free of defects
in both materials and workmanship for the period
lawfully stipulated starting from the date of original
purchase. Should the product develop any failure
during this period due to defective material and/or
workmanship then contact VONROC directly.
WWW.VONROC.COM
Publicité
Table des Matières
