Weka 593.4050 Série Notice De Montage, D'utilisation Et D'entretien page 87

Masquer les pouces Voir aussi pour 593.4050 Série:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

4. Grime and grease which have been deposited as a water mark on the edge of the pool, can be
simply removed using the pool edge cleaner: This alkaline cleaner easily removes grime, fat and
cosmetic stains. The pool edge cleaner can be used neat or diluted with water to form a foam. Wet
down the area and wipe the cleaner over the accumulated dirt. Allow the cleaner to have an effect
and then rinse immediately with clean water. For stubborn stains, simply repeat this treatment again.
5. To prevent your swimming pool turning into a foam bath when it is refilled, you should rinse it out
thoroughly after cleaning. It is also important that you use only the recommended agents and not
household cleaners to clean your pool. If you do not, the effectiveness of your water treatment
products may be adversely affected. Some base materials in household cleaners do not react well
with the water treatment agents.
Instructions for refilling the swimming pool:
Check the filter system and replace the filter sand if necessary.
First adjust the pH level (ideal: 7.0 – 7.4). This is followed by a basic disinfection or intermittent chlorination.
After a few days, continue with normal water maintenance as follows:
1. pH value regulation
2. Disinfections
3. Algae prevention
4. Flocculation
6. Cleaning and maintenance
Instructions for perfect overwintering
In accordance with the season, preparations for the overwintering of your open-air swimming pool begin in
the autumn.
Empty 1/3 of the water and simply cover the pool with a liner. Any layer of ice which occurs will not damage
your pool. Drain all pipes and devices and store them such that they are protected against the snow.
The pool is drained using the brush cleaning set and the filter system.
Overwintering products prevent the crystallisation of mineral salts, i.e. the formation of irritating limescale is
considerably reduced. The growth of resistant algae types as well as the contamination of the joints, corners
and edges is prevented or markedly reduced.
The application: Once the swimming season has ended, and when free chlorine is still present, wait a few
days. Once the water level has dropped below the mounting parts, add the overwintering product depending
on the current water hardness:
Water volume
10 m³
20 m³
30 m³
40 m³
50 m³
)* Take note of the information for the product used
Tip 1: In early spring, a few weeks before cleaning, add half of the autumn dose again. During spring
cleaning, when you drain away the old water, this will save you a great deal of cleaning.
Technische Änderungen vorbehalten! Alle Maßangaben sind ca. Maße.
Overwintering product required for water hardness )*
up to 25 German
degrees
100 ml
200 ml
300 ml
400 ml
500 ml
86
up to 30 German
degrees
200 ml
400 ml
600 ml
800 ml
1,000 ml
 Copyright HRB 3662
30 German degrees
and above
up to 400 ml
up to 800 ml
up to 1,200 ml
up to 1,600 ml
up to 2,000 ml

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

593.5060 série

Table des Matières