Publicité
Les langues disponibles
Les langues disponibles
Germicidal Lamp Replacement
1.
Unplug the Germicidal Monitor from the power source.
2.
Remove the wire rack by pulling the bottom of the rack upwards to disengage from the bottom hook.
3.
To remove the Germicidal Lamp, simply rotate the lamp clockwise or counter-clockwise to unlock from the base.
4.
Contact your local hazardous waste management authority for proper recycling/disposal instructions for UV lamps that
apply to your state.
5.
Contact Sellstrom Customer service for replacement lamp ordering and before removing any electrical components.
Product Specifications
•
For indoor use only
•
Rated for altitudes up to 4,000 meters
•
To be used within temperatures of 0 to 40°C
•
Maximum relative humidity 80% for temperatures up to 31°C decreasing linearly to 50% relative humidity at 40°C
•
Installation Category II
•
Pollution Degree II
•
Rated IP30
•
120 VAC, 60 Hz, 0.25 Amp
•
Rated Line Voltage Range – 7.5% to +5%
•
The Monitor may be used in a continuous operation.
•
Sellstrom's Hyper-Germicidal Lamp has its UV output peaked at the optimum germicidal wave length of 2,537 angstroms.
•
Designed with a quick acting 10-Amp fuse to protect against accidental overloads.
Product that works.
MON236 rev4
Page 3 of 3
Publicité
