Sensor Wiring - Bell EZFit Mode D'emploi

SENSOR WIRINg
Route the sensor wire up the fork blade,
using the cable ties to secure it at the
bottom and crown. Wire must not hang
loosely. Leave enough slack to allow wheel
to turn right and left freely. Route the
remaining wire around the front brake cable
and to the handlebar. Excess wire should
be carefully looped and secured to the stem
with a cable tie.
Note: Make sure cable tie ends are cut so
as to not interfere with operation of bicycle.
10
Computer
Sensor
Brake cable
Sensor wires
Magnet