Ebode RPA Guide Utilisateur page 7

Receiver - Plug-In Appliance Module
Reset appliance module addresses
1. Use a small sharp object, e.g. a paper clip, to press and hold the
setup button until the green led turns on. (about 3 or 4 seconds)
2. Release the button, the led will blink red and green and then
turn off.
3. When the red and green LEDs are off, the module is reset.
Operating the RPA module
Gently press the upper key (ON) on i.e. EM, TPC, to turn on the appliance/light.
Gently press the lower key (OFF) on i.e. EM, TPC, to turn of the appliance/light.
Tips
- Knowledge base available on www.ebodeelectronics.eu.
Can I plug appliance receiver into a power strip?
This is no problem with a simple power strip however you can not use the module
with a surge protected power strip.
I'm using a X10 compatible wireless remote, e.g. TPC, IMRF, EM, SS13,
KR22, SH600 or HR10, but the RPA is not responding?
- Check and/or change remote control battery.
- Check if your transceiver is correctly connected.
- Reset the RPA (see paragraph 3) then reprogram the address.
The RPA does not respond to command sent via the power line?
Reset the RPA (see paragraph 3) then initialize the address.
July 2009 page 7
Ref : RPA
RPA