Kreg Jig K5 Guide D'utilisation page 5

K5 and K5 Master System Parts
R
Vacuum port
Accepts a 1¼" (32mm) shop vacuum hose for efficient chip removal, swivels side to side
S
Extension Wings
Provide support for wide workpieces and storage for bits and accessories
T
Screw-length selection guide
Apply this self-adhesive label to the inside of an extension lid for easy reference
U
Spacer block
In repair applications, positions the drill guide for drilling pocket holes in
¾" (19 mm)-thick material
V
Pocket-screw sample pack
Contains 10 each of the five most often used screws
W
Pocket-hole plug sample pack
Contains five paint-grade wood plugs
Additional Master System Parts
The K5 Master System includes the following parts
X
Portable base
Accepts Micro, Standard, and HD drill guide blocks. Useful for large panels or
assemblies that would be difficult to clamp into a bench-mounted jig. Built-in cams
secure the portable base to your Kreg clamp.
3" Wood Project Clamp with Automaxx
Y
Provides fast and secure clamping when assembling a pocket-screwed joint. Set
the desired pressure and this 3"-reach clamp automatically adjusts to any
material thickness up to 3" (76mm).
Using the Kreg Jig
To create strong joints, you'll set your jig to match the
thickness of the workpiece and the length of the screw.
The Kreg Jig makes this easy, in just four simple steps:
®
Parts
K5 and K5 Master System
®
®
www.kregtool.com
4