Specification; Dimensions And Connections - Stiebel Eltron DNM 3 Utilisation Et Installation

INsTALLATIoN

Specification

f Close the shut-off valve in the cold water inlet line. f
f Open the draw-off valve. f
f Undo the water connections on the appliance. f
Cleaning the strainer
You can clean the fitted strainer after removing the cold water
supply pipe.
Checking the earth conductor
f Check the earth conductor (in Germany e.g. BGV A3) on the f
earth conductor contact of the power cable and on the appli-
ance connector.
Appliance storage
f Store the dismantled appliance in a room free from the risk f
of frost, as water residues remaining inside the appliance can
freeze and cause damage.
36 | DNM
Replacing the power cable for the DNM 6
f When replacing the cable for the DNM 6, use a power cable f
with 4 mm² cross-section.
15. Specification

15.1 Dimensions and connections

c01 c06
30
120
190
b02 Entry electrical cables I
b03 Entry electrical cables II
c01 Cold water inlet
c06 DHW outlet
20
b02
b03 82
DNM
Male thread G 3/8 A
Male thread G 3/8 A
www.stiebel-eltron.com