General Information; Storage And Transport - Ex-Tech DE1WH Série Mode D'emploi

1. General information

The operating instructions must always be preserved during the lifetime of the product. It summarizes the
key safety measures.
It must be read by everyone working with the product so that they know to handle it properly.
The increased safety enclosures Ex e must be used only for the purposes for which it was intended.
EX-TECH SOLUTION shall not be held liable for damages resulting from incorrect or improper use or non-
compliance with this manual.
Only authorized and trained persons are authorized to perform work on increased safety enclosures Ex e
(installation, commissioning, maintenance, maintenance).
During installation and operation, it is imperious to follow the instructions (technical characteristics and
operating conditions) written on the marking plate of the increased safety enclosures Ex e.
2. Manufacturer
– Formerly Technor Atex
Ex-tech Solution
22, impasse de la Volute – Z.A. les Montagnes
B.P. 20708 – 16430 Champniers – France
Tel: + 33 5 45 93 01 10 – Fax : + 33 5 45 93 01 15
E-mail: sales.solution@ex-tech.no – www.ex-tech.no

3. Storage and transport

 Check that the product was not damaged during the transport. If necessary, make a complaint to the
carrier
 Never turn on damaged products
 The product should be stored for a maximum of two years into a place dry (no condensation),
enclosed, covered, protected from contact with external chemicals and to temperatures of -40 ° C ... +
70 ° C and vibration-free
4. Use
The increased safety enclosures Ex e described in this manual are certified II 2 GD and can operate into
the classified zones 1 and 2 for gases or 21 and 22 for dusts.
DE1037A12-06 du 01/12/2016
Operating instructions
Increased safety enclosure - DE1WH / DE1GW series
ENG
7/12