Pelgrim ISW0960WIT Notice D'utilisation page 37

USE
Grease filter indicator
• The 'S1' warning lamp lights when the grease filter must be
cleaned.
• The warning lamp lights after 100 hours of use. This indicates
that the grease filter must be cleaned.
• Reset the signal lamp by touching the 'T3' key for 3 seconds.
▷ The 'S1' warning lamp flashes 3x to confirm that the signal has
been reset.
Carbon filter indicator
• Activate the carbon filter fouling indicator by touching the 'L' key for
5 seconds.
▷ The 4 LED indicators will flash 2x as confirmation.
▷ The 'S1' warning lamp flashes after 200 hours use of the cooker
hood (when the carbon filter fouling indicator has been activated)
to warn that the carbon filter must be replaced.
• Switch the indication off by touching the 'L' key again for
3 seconds.
▷ The 4 LED indicators flash 1x as confirmation.
Activating the remote control
• Touch the T4 key for 5 seconds.
▷ The remote control is activated.
▷ The T4 LED flashes 1x.
Operating using the remote control
A1
A2
A4
L1
A3
A5
EN 7