Table des Matières
Publicité
6
www.electrolux.com
5. CONTROLS
•
The hood is equipped with buttons
for suction speed control. It is
recommended to turn on the hood a
few minutes before starting to use the
cookers and let it run for about fi fteen
minutes after you have fi nished cooking
in order to eliminate all odors.
•
In case of extreme temperature
changes, the hood will start
automatically due to the existing sensor
and will remain in operation until the
temperature around the hood will
signifi cantly decrease.
•
The control panel of the hood is located
on front of the unit.
1
1
On/Off Button
Pressing this button, the hood is
activated at speed 1.
The hood will turn off when the button is
pressed while in operation.
2
Motor speed
Pressing this button, the hood switches
from off to speed 1.
Pressing subsequently this button more
than once (with the hood in operation),
the motor speed will change:
Speed 1: "1" appears on the display.
Speed 2: "2" appears on the display.
Speed 3: "3" appears on the display.
Intense Speed: "4" fl ashes on the
display.
Intense Speed has a timer.
Standard duration of the timer is 5 ',
after which the hood passes at speed 2.
To disable this feature before the end
of the preset duration, press button "2"
so that the hood passes to speed 1. By
pressing subsequently button "1", the
hood will be turned off.
3
Light On/Off
4
Button On/Off Sensor
5
Display
2
5
Timer
To activate the speed timer, press
seconds.
After the time indicated according to the
chosen speed, the hood is off.
The timer operates in the following manner:
• Speed 1: 20 minutes (the display shows
• Speed 2: 15 minutes (the display shows
• Speed 3: Display 10 minutes (the display
• Intense Speed: 5 minutes (the display
During operation of the hood with the timer,
if you press
press
med speed and if you press button
hood switches to Sensor .
The grease fi lter saturation signal
"1" fl ashes to indicate that the grease fi lter
must be cleaned. This happens after the
3
4
hood is used for approximately 80 hours.
After cleaning the grease fi lter, hold button
"1" for 3 seconds until the indicator light
stops fl ashing.
Read carefully the directions for grease
fi lter cleaning.
Charcoal fi lter saturation signal
"2" fl ashes when the charcoal fi lter must
be replaced. This happens after the hood is
used for approximately 320 hours.
After replacing the activated charcoal fi lter,
hold button
indicator light stops fl ashing.
Read carefully the directions for cleaning
the charcoal fi lter.
In case both fi lters are saturated, "1" and
"2" fl ash simultaneously.
To perform the reset, the above procedure
must be repeated twice.
First, the saturation indication of the grease
fi lter is canceled and the second time will
cancel the saturation indication of the
charcoal fi lter.
In standard mode, the device that signals
the saturation of the charcoal fi lter is
disabled.
In case the hood is used in recirculation
mode, this signal must be activated.
"1" and a fl ashing dot).
"2" and a fl ashing dot).
shows "3" and a fl ashing dot).
shows "4" and a fl ashing dot).
"1"
the hood turns off, if you
"2"
the hood passes at the program-
"1"
for 3 seconds until the
"2"
for 2
"4"
the
Publicité
Table des Matières
