Electrolux EFC 50800 Manuel D'utilisation page 6

6 www.electrolux.com
5. CONTROLS
The hood is fi tted with a control panel with
aspiration speed selection control
and a light switch to control cooking area
lights. Use the high suction speed in cases
of concentrated kitchen vapours. It is
recommended that the cooker hood suction
is switched on for 5 minutes
prior to cooking and to leave in operation
during cooking and for another 15
minutes approximately after terminating
cooking.
1
The electronic controls on your ducting
cooker hood have multiple
functions-features:
- Motor on-off function
The motor is turned on and off by
pressing pushbutton nr. 1. When you
turn on the cooker hood it automatically
starts running at the third speed. Nr. 6
speeds.
To select the required speed use
pushbuttons nr. 2 and nr. 3. The speed
setting is given on the display provided
for this purpose. It is possible to
modify these 6 speeds from intensive
mode "H" , display flashes, to normal
mode "L". To do this simply press
pushbutton 5 (LAMP) for five seconds.
When modifying speed mode the
cooker motor must be off.
- Timer function
This function permits you to program
your cooker hood so that the motor and
lights turn off automatically 10 minutes
after you have activated this function.
To program press pushbutton nr. 4. At
the bottom on the right of the display a
point will flash indicating that the timer
function is activated.
- Lights on-off function
To turn the lights on and off press
pushbutton nr. 5
- Specific features
The electronic controls provided
on your ducting cooker hood have
2 3
-
After every 40 hours of use a
To delete this prompt, once the filters
zeros the number of hours and starts
4 5
- Prompt - replace active carbon filters
If your cooker hood utilizes the re
extraction system. To do this, always
maintain pushbutton nr. 4 pressed for 5
up on the display (this indicates the
prompt is indicated by the letter "C"
guarantee better filtering performance
To delete this prompt, once the
zeros the number of hours and starts
advanced features to facilitate
maintenance and correct utilization.
Prompt - clean metal filters
microprocessor, heart of the system,
prompts the user that it is time to clean
the metal grease filters to guarantee
better ducting performance and to
improve hygiene. This prompt is
indicated by the letter "A" which flashes
on the display.
have been cleaned and with the cooker
hood off (not powered), maintain
pushbutton 2 pressed for more 14
than 5 seconds. When you press this
pushbutton the letter "A" will come up
on the display and then disappear after
5 seconds. The microprocessor
a new count from zero until reaching
40 hours prompting this maintenance
procedure.
(if mounted)
circulation air filtering system and
therefore is fitted out with active carbon
filters for purifying the vapors extracted,
it is necessary that you program the
microprocessor for this
with the cooker hood off (not powered),
seconds. The symbol " –" will come
cooker hood is not provided with a
carbon filter) and after 5 seconds this
symbol changes to "C" (now indicating
the cooker hood is provided with a
carbon filter). After every 80 hours of
use the microprocessor will prompt the
user to replace the carbon filter. This
which flashes on the display. This is to
and to improve hygiene.
filters have been replaced and with
the cooker hood off (not powered),
maintain pushbutton 3 pressed for
more than 5 seconds. When you press
this pushbutton the letter "C" will come
up on the display and then disappear
after 5 seconds. The microprocessor
a new count from zero until reaching